Siemens Sinumerik 810T - Manual (Page 104)

3 Operating Sequences 01.93
3.1.4 Tool offset
4 Diameter/radius
2 L1 Geometry
Under points P = ”2” and P = ”3”, you enter
the geometry values of the turning tools into
the input field
Under point P = ”4” you enter the value of the
cutter radius.
3 L2 Geometry
2. Grooving tool
(left tip) 1. Turning tool
Facing tool
L2
L1
L2
L1
Geometry values of the available
tool types:
The input of tool geometry values can be inhibited with
a key switch.
5 L1 Wear
Under points P = ”5” to P = ”7”, you can (not
obligatory) enter the wear data of the tools into
the input form.
The machine tool manufacturer can set the
maximum wear input to ± 0.999 mm.
6 L2 Wear
7 Diameter/radius
The input of tool wear data can be inhibited by means
of a key switch!
3-6 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)