Siemens Sinumerik 810T - Manual (Page 239)

3 Operating Sequences 09.91
3.2.12 ”Repositioning” mode (”REPOS”)
and
... set the operating mode selector switch on the external
machine control panel to this symbol.
Prerequisite:
You have generated a program interruption - e. g. by switching to “JOG” mode - and sub-
sequently traverse away from the contour (see Section 3.2.7 for sequence of operation).
Operate the operating mode selection key on the inte-
grated machine control panel and then the ”REPOS”
softkey or...
REPOS
or
Sequence of operation
This display appears on the CRT.
(( 810T))
(( Bild 9 von Druckerei
einmontieren
The red ”Feed hold” LED display is extinguished.
3-132 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)