Siemens Sinumerik 810T - Manual (Page 106)

3 Operating Sequences 09.91
3.1.4 Tool offset
You select the desired tool offset number, in the range D1 ...
D99, by operating either the ”Page forward” or ”Page
backwards” key.
or
you call the desired tool offset number D ... (”5”, in this
example). The letter D need not be entered.
Now press the Search key.
Now operate any of the cursor keys to position the cursor at the
desired input field (Identifiers 1 .. 9).
Then enter your desired offset value (”153” in this example) with
the numeric keys.
You can see the entered value on the input line of the display.
Now operate the yellow input key, and store the offset value in
the offset memory.
The value you input is now displayed in the selected input field.
• The inverse video marking of the input field now automatical-
ly jumps to the next position (next identifier P ..) of the
selected offset number D ... .
• After storing all the offset values of the selected offset
number D..., the inverse video marking of the input field now
jumps to the first offset value of the following offset
number.
or
1
F
3
L
5
J
5
J
3-8 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)