Siemens Sinumerik 810T - Manual (Page 24)

2 Operation 09.91
2.1.1 SINUMERIK 810T operator interface with integrated machine control panel
Numeral: 7
Address for: ”Position information” axis X .....
Numeral: 8
Address for: ”Position information” rotary axis
C .....
Numeral: 9
Address for: ”Position information” axis Z .....
Letter e 1)
Address for: ”Position information” auxiliary
axis Q .....
Symbol for: ”Division”
Address for: ”Program control function” @ .....
Numeral: 4
Address for: ”Interpolation parameter” I .....
Numeral: 5
Address for: “Interpolations parameter”J .....
Numeral: 6
Address for: ”Interpolation parameter” K .....
Letter f 1)
Address for: ”Radius” B .....
Key assignment changeover:
With successive operations of this key you make either the upper or
lower symbols of the double function keys active.
– yellow LED (see Section 2.1.1.2) lit: lower symbols are active
– yellow LED not lit: upper symbols are active
1) Note: These letters are not permissible for normal programming. They are used for input of, or changes to,
commands in ”CL800” Machine Code (@ ...) .
7
X
8
C
9
Z
4
I
@
Q
5
J
6
K
B
2-8 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)