Siemens Sinumerik 810T - Manual (Page 286)

6 Data Interfaces 01.93
6.4 Device connection data
Siemens Programmer
PG 685/675/670/730/750
Interface S5 PLC
Cable Order No.: 6FC9 340-8G
6FC9 344-4R
(PG 750/730 only)
Device data
Interface: 20 mA current
loop
Transfer rate: 9600 baud
Character format: 1 Start bit,
7 Data bits,
1 Parity bit (even
parity),
2 Stop bits
Operating conditions
For PLC programming the PG 685/675/
670/750 programmer should be connected
directly to interface 1 (20 mA current loop
interface) on the SINUMERIK 810T.
(If cable 6FC9340-8G is used with the
PG 750, the supplied adaptor must be
used)
Siemens Programmer PG 675/685
Interface Printer
Cable Order No.: 6FC9 344-1A.
Device data
Interface: RS232C (V.24)
Transfer rate: 1200 baud
Character format: 1 Start bit
8 Data bits
2 Stop bits
Operating conditions
Archiving of NC cycles and programs onto
disk, and the transfer to and from the NC
and the creation of programs is possible
with the PG 675/685.
For data transfer, the PG 675/685 should
be connected from the printer interface to
an RS232C (V.24) interface on the
SINUMERIK 810T.
Siemens programmer PG 615 U with
PG 615 adapter and power pack
Interface PLC
Cable Order No.: 6FC9 340-8H.
Device data
Interface: 20 mA current
loop
Transfer rate: 9600 baud
Character format: 1 Start bit
7 Data bits
1 Parity bit
(even parity)
2 Stop bits
Operating conditions
For PLC programming the PG 615 program-
mer is connected via the adapter and a cable
to interface 1 (20 mA current loop) on the
SINUMERIK 810T.
6-6 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)