Siemens Sinumerik 810T - Manual (Page 37)

09.91 2 Operation
2.1.1 SINUMERIK 810T operator interface with integrated machine control panel
Key for the selection of operating modes
You use this key when you want to select operating modes or further
softkey functions.
The menu selected is shown on the bottom two lines of the CRT display
(menu for softkey functions see Section 2.1.1.1).
Operate the key
until you see the menu for the following operating modes displayed:
Operate the key a second time
A menu of further softkey functions is displayed.
The menu displayed depends on the current operating mode, which is
shown on the first line of the display (see Section 2.1.1.1).
For detailed information see Sections 2.3.3 to 2.3.6 and 2.4 !
You can extend the displayed operating mode menu:
Operate the ETC key below the CRT
The extension of the operating mode menu is shown :
Section of the CRT display with menu of the operating modes
REPOS AUTO-
MATIC
JOG MDI-
AUTOM.
PRESET
Section of the CRT display:
1st extension of the operating mode menu
INC
1 000
INC
10 000
INC
100
INC
10
INC
1
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 2-21
SINUMERIK 810T, GA3 (BN)