Siemens Sinumerik 810T - Manual (Page 179)

3 Operating Sequences 09.91
3.1.14 “SIMULATION”
Using the softkey, select the ”BLOCK SEARCH” func-
tion.
b) “BLOCK SEARCH”
BLOCK
SEARCH
This display is shown on the CRT.
((Bild 810T/34 einmontieren))
SIMULA-
TION
Operate the”START” softkey.
Using the keyboard, enter the desired block number
”N...” (”25” in the example; ”N” need not be
entered) and store it with the input key.
Now the simulation does not start at the beginning of the program, but at the point set by
the selected block (in the example “N 25”).
Operate the “SIMULATION” softkey and then the
ETC key to extend the softkey menu. This brings
you back to the softkey menu for influencing
simulation.
START
2
D
5
J
3-76 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)