Siemens Sinumerik 810T User Manual
Page 34
2 Operation
09.91
2.1.1 SINUMERIK 810T operator interface
with integrated machine control panel
Example for the use of ”Spindle stop”
•
during operation in ”MDI AUTOMATIC” mode, a block with a
fault is discovered
•
in ”JOG”, ”INC..”,”REPOS” modes e.g. during
repositioning to the contour
•
to change a tool
•
to input S, T, H, M functions during setting up
(overstore)
You operate the ”Spindle start” key:
•
the spindle speed reaches the value specified in the part
program.
The following values are specified in machine data:
- the maximum spindle speed
- the values for spindle speed override
switcxh positions.
Feed hold/ Feed start
When you operate the ”Feed hold” key:
•
the feed drives are brought to a defined standstill
•
the red ”Feed hold” LED
lights up.
Examples of the use of ”Feed hold”
•
during operation in ”MDI AUTOMATIC” mode, a block with a
fault is discovered
•
in ”JOG”, ”INC..”,”REPOS” modes , e.g. during repositioning to the contour
•
to change a tool
•
to input S, T, H, M functions during setting up (overstore).
2-18
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)