Siemens Sinumerik 810T - Manual (Page 92)

2 Operation 09.91
2.5 Glossary of softkey functions
LIST OF TOOLS
The location number and tool number of worn tools is displayed.
MACH. DATA
(MACHINE DATA)
Using machine data (MD) the control is interfaced to the machine. Certain functions are
defined with machine data (e.g. ”Dry run feedrate locked with keyswitch”).
A differentiation is made between NC MD and PLC MD. NC MD are divided into general data,
axial data and spindle data; the PLC MD are divided into system data and user data. Machine
data are fixed at the time of installation and should not be changed by the user.
You select the output of machine data with the ”MACH. DATA” softkey after ”DATA OUT”.
MAINPRG. START
(MAIN PROGRAM START)
You activate the output of part programs via the universal interface.
MAIN PROGRAM
The following is shown in the display which appears if you press this softkey:
– the numbers of the main programs stored
– the number of characters taken up in memory
– the free memory capacity.
MOVE
You shift the selected part program to the end of memory. Only the program at the end of
memory can be edited at the same time as another program is being processed.
NC ALARM
All current NC alarms are displayed (see Section 4).
NC MD
(NC MACHINE DATA)
The NC machine data are displayed.
OPS
(PROGRAM SEQUENCING)
With this function you can load programs from a disk drive unit into the NC and execute them.
OPT. STOP YES-NO
(PROGRAMMED STOP ON-OFF)
With ”YES”, the processing of the program is stopped at the point at which the ”M01”
command is programmed.
OVERR. YES-NO
(FEED / RAPID OVERRIDE ON-OFF)
When ”YES”, the set override is valid for the rapid traverse override/feedrate override switch.
2-68 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)