Siemens Sinumerik 810T - Manual (Page 110)

01.93 3 Operating Sequences
3.1.4 Tool offset
3.1.4.4 Automatic tool offset
This function requires a tool gauging device.
The coordinates of the measuring point of the workpiece (referring to the machine) should be
entered as ”Reference plane” point. This is achieved by coordinating the point of the turning
tool with the measuring point and reading off the X and Z values on the gauging device. The
tool must be selected from type 1 ... type 9.
Using a softkey, select either of the ”JOG” or ”INC 1... 10 000”
operating modes.
Now coordinate the tip of the turning tool with the measuring
point of the tool gauging device.
Now operate the ”AUTOMATIC TOOL OFFSET” softkey.
Extend the softkey menu displayed, using the ETC key to the
right below the display.
JOG INC...
or
AUTOM.
TOOL
Sequence of operation
This input screen form appears with
the input field marked in inverse video.
((Bild 810T/17 einmontieren))
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-11
SINUMERIK 810T, GA3 (BN)