Siemens Sinumerik 810T - Manual (Page 193)

3 Operating Sequences 01.93
3.2.2 ”AUTOMATIC” operating mode - selection of the ”CURRENT VALUES” or ”CURRENT BLOCK” display
3.2.2 ”AUTOMATIC” operating mode
- selection of the ”CURRENT VALUES” or ”CURRENT BLOCK”
display
Precondition:
An active program is being processed in ”AUTOMATIC” mode.
Operate the operating mode selector key in the integrated
machine control panel, and then the ”AUTOMATIC”
softkey, or...
... set the operating mode selector switch on the external
machine control panel to this symbol. or
and
AUTO-
MATIC
Sequence of operation
The ”CURRENT VALUES” basic
display for the active program is shown
on the CRT - in the example, for the
program ”%88”.
(( 810T))
(( Bild 3 von Druckerei
einmontieren
You can extend the displayed softkey menu with this key.
3-90 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)