Siemens Sinumerik 810T - Manual (Page 187)

3 Operating Sequences 09.91
3.1.15 Data input/data output
MAINPRG.
START
R PARA-
METER
Using the ”STOP” softkey, you can interrupt data output
at any time.
Start data output again.
After the transfer (data output) is complete, return to a
higher-level softkey menu using the RECALL key.
Using the ETC key you can extend the displayed softkey
menu.
The displayed function gives you the possibility to output
all the ”R parameters”.
Operate the ”R parameter” softkey.
PLC MD > PART
PROGRAM TOOL
OFFSET ZERO
OFFSET MACH.
DATA
You can now call any of these
functions for data output
(”PART PROGRAM” known -
see above).
SUBROUT.
START
or
STOP
R PARA-
METER
3-84 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)