Siemens Sinumerik 810T - Manual (Page 184)

01.93 3 Operating Sequences
3.1.15 Data input/data output
Meaning Data type
MPF Part program (Main Program File)
SPF Subroutine (Sub Program File)
TOA Tool offset (Tool Offset Active)
ZOA Zero offset (Zero Offset Active)
TEA 1 NC machine data (TEsting Data Active 1)
TEA 2 PLC machine data (TEsting Data Active 2)
PCA PLC alarm text (Programmable Control Alarms)
PCP PLC program (Programmable Control Program)
RPA R parameters with assigned values (R Parameter Active)
SEA Addresses with assigned values (SEtting Data Active)
UMS User Memory Submodule
CLF Clear instruction (CLear File)
Under Interface Assignment: the control gives you the identifier of the connected
device type for Interface 1 and Interface 2. (For identification of various device types see
Section 6.3)
Using the ”STOP” softkey, you can interrupt data input at any time.
You continue data input again.
STOP
DATA-IN
START
During data input it is not possible for the control to call up
specific data!
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-81
SINUMERIK 810T, GA3 (BN)