Siemens Sinumerik 810T - Manual (Page 148)

11.90 3 Operating Sequences
3.1.10 Program input
This display appears on the CRT.
The control shows you the last part
program called, in the example
program no. ”%88”.
((Bild 810T/11 einmontieren))
BLOCK
NUMBER
GUIDING
SELECT
PROGRAM
EDIT
Using the ”SELECT PROGRAM” softkey call the desired
program.
Operate the ”EDIT” softkey.
Enter the desired program no. ”%12”.
Operate the ”GUIDING” softkey.
Operate the ”BLOCK NUMBER” softkey. The
block number ”N0005” is displayed.
Note:
The block numbers are generated by the control in steps
of 5, i.e. after each LF (end of block) the block number is
incremented by ”5”.
%
1
F
2
D
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-47
SINUMERIK 810T, GA3 (BN)