Siemens Sinumerik 810T - Manual (Page 292)

7 Interfacing to the Machine 09.91
7.3 SINUMERIK 810T machine data
7.3 SINUMERIK 810T machine data
7.3.1 General machine data
In this section you will find tables of machine data, whose values can be changed from the
standard values by the machine tool manufacturer at any time.
In the column you can enter the value displayed on the CRT of the control
delivered.
Set value
You must only check the machine data displayed,
you must not modify them.
Sequence of operation: Calling general machine data
Operate the mode selection key on the integrated machine
control panel, and then any operating mode softkey.
or select any operating mode using the mode selector
switch (external machine control panel).
To call up the CRT display, proceed as follows ...
Operate the ETC key to extend the softkey menu,
and then the ”DIAGNOSIS” softkey.
DIAG-
NOSIS
7-4 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)