4 interrupting the program – Siemens Sinumerik 810T User Manual
Page 208
3 Operating Sequences
01.93
3.2.3 Influencing ”AUTOMATIC” operation
3.2.3.4
Interrupting the program
Sequence of operation
Now operate the ”NC Start” and ”Feed start” keys.
The feed is enabled again.
Operate the ”NC STOP” key.
The feed drives are brought to a controlled standstill
without leaving the programmed path.
The “STOP: AUTO INTERRUPTED” display appears.
You can interrupt a running program in one of the following ways:
1) Perform one of the operating mode changes which causes a reset (see Section
2.3.4). The drives are brought to a controlled standstill.
2) By NC STOP:
The axis positions programmed in the current block are
approached with linear interpolation.
Caution: danger of collision!!
3-104
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)