Siemens Sinumerik 810T - Manual (Page 114)

09.91 3 Operating Sequences
3.1.4 Tool offset
Enter the geometry data in this screen form. Note that the location number in the magazine
table (e. g. 3) is the same as the D No. of the tool offset memory (e. g. D3).
Press the “GEOMETRY DATA”softkey to return to the ”TOOL OFFSET ” menu. You can
return to the standard menu by pressing the “RECALL” key twice.
If you are entering tool data from paper tape, observe
the instructions of the machine manufacturer.
3.1.4.7 Display of tool data
GEOM.
DATA
TOOL
OFFSET
Press either “TOOL OFFSET” softkey or the
“GEOMETRY DATA” softkey.
or
D...
Press the approriate keys to page through the display
and select a certain D No. input is then displayed.
or
Select a D No. and press the search key. The tool
data under the D No. input is then displayed.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-15
SINUMERIK 810T, GA3 (BN)