Siemens Sinumerik 810T User Manual
Page 94
2 Operation
09.91
2.5 Glossary of softkey functions
PROGRAM CONTROL
(INFLUENCING THE PROGRAM)
The key leads to the following functions:
– SKIP BLOCK
– DRY RUN FEEDRATE
– PROGRAMMED STOP
– RAPID OVERRIDE
– DECODING SINGLE BLOCK
– DRF HANDWHEEL ENABLE
– DRF
PROGRAM END
You select the functions of the ”M02” (end of program) group via softkeys.
PROG. HANDL.
(PROGRAM HANDLING)
You can copy, move, rename and delete the program in the program memory. You can
reorganize the program memory (after deleting programs) (see ”REORG”).
RENAME
You can change the program number.
The program itself remains unchanged.
REORG
(REORGANIZE)
You can reorganize the program memory.
The space that has been made available by the deletion of programs can be used again for
entering further programs.
R PARAMETER
You input the R parameters as setting data.
– After ”DATA OUT”, you can select the output of R parameters with the ”R PARAMETER”
softkey.
RESET
Simulation is interrupted and returned to the reset state.
ROTAT. ANGLE
(ANGLE OF ROTATION)
Input of setting data for coordinate system rotation.
SCALE MODIF.
(SCALE MODIFICATION)
Input of setting data for scale modification.
2-70
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)