Siemens Sinumerik 810T - Manual (Page 222)

3 Operating Sequences 11.90
3.2.5 ”TEACH IN”
3.2.5 ”TEACH IN”
Using the ”TEACH IN” function in the ”AUTOMATIC” operating mode you can generate a part
program on a block-by-block basis.
You can test the program immediately.
Operate the operating mode selection key on
the integrated machine control panel, and
then the ”AUTOMATIC” softkey
or...
... set the operating mode selector switch on
the external machine control panel to this
symbol.
Enter the desired program no. ”% ...” (or
subroutine no. ”L ...”) in the ”AUTOMATIC”
basic display.
Operate the ”PART PROGRAM” and
”TEACH IN/PLAYBACK” softkeys, one after
the other.
The selected part program no. with the input pointer below it are displayed.
Using the numerical keyboard, enter a block
(or more than one block) following the
guidelines in the Programming Instructions,
and terminate each input - including ”LF”
(end of block) - with the input key.
Note :
You can also work with operator -
”GUIDING” (see Section 3.1.10.2).
The part program is entered directly into the
part program memory.
AUTO-
MATIC
and
or
PART
PROGRAM TEACH IN
PL. BACK
and
%
...
N
...
G
...
X
7 ...
LF
+
Sequence of operation
3-116 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)