Siemens Sinumerik 810T - Manual (Page 147)

3 Operating Sequences 11.90
3.1.10 Program input
Select one of the following operating modes:
• PRESET ( Actual value setting )
• JOG ( Feed/jog )
• AUTOMATIC ( Automatic operation )
• INC 1 ... INC 10 000 ( Incremental jog )
• REFPOINT ( Traverse to reference point )
and
Now operate the ”PART PROGRAM” softkey.
PART
PROGRAM
You wish, for example, to enter block ”N5 G90 G00 X25 LF” into program no. ”%12”:
To do so, you use the operating mode selection key, and then the corresponding softkey
(see above) or the operating mode selector switch (external machine control panel).
Sequence of operation
Please note:
Apart from program input, the PART PROGRAM function also serves for
– Program editing (see Section 3.1.12)
– Program management (see Section 3.1.13)
– Program simulation (see Section 3.1.14).
3-46 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)