Siemens Sinumerik 810T - Manual (Page 151)

3 Operating Sequences 11.90
3.1.11 Contour
3.1.11 Contour
The ”CONTOUR” softkey function is an extension of ”Program input with operator guiding”
(see Section 3.1.10.2).
With ”CONTOUR” you can select contour elements. Graphics displays support the program-
ming of specific geometric contour values.
Now operate the ”PART PROGRAM” softkey.
PART
PROGRAM
EDIT
Operate the ”EDIT” softkey.
Use the numerical keys to enter the
desired program no. %... .
As described in Section 3.1.10.1 or 3.1.10.2 - select any of the operating modes:
• PRESET
• JOG
• AUTOMATIC
•
INC 1 ... INC 10 000
• REFPOINT
... ...
%
Sequence of operation
3-50 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)