Siemens Sinumerik 810T - Manual (Page 260)

4 Monitoring Functions 01.93
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
2059
”G92 program error”
Reason:
Remedy:
– Use of an invalid address character
– Error on cylindrical interpolation
G92 is only allowed with address ”S” (programmed spindle speed
limitation) or “P” (cylindrical interpolation)
Alarm No.
Alarm Text:
2060
”TO, ZO program error”
Reason: – A non-existent tool offset number was selected
– The value in the selected zero offset or tool offset is too large
Alarm No.
Alarm Text:
2061
”General program error”
Effect:
Reason: Inhibiting of NC START
– Contour calculation not possible
– Machine data for ”axis duplication” function incorrect
Alarm No.
Alarm Text:
2062
”Feed missing/not prog.”
Reason:
Remedy:
– No F value programmed
– F value too small (machine data)
– Feed per rev., G95 greater than 50mm/min per revolution
– No feed per rev. programmed
– The axial distance to go for the rotary axis with G98 or G36 is 0 or
no G98 feed has been programmed.
Program correct feed
Alarm No.
Alarm Text:
2063
”Thread lead too high”
Reason:
Effect:
Remedy:
A thread pitch of more than 400 mm/rev.
(16 inch/rev.) has been programmed.
Inhibiting of NC start
Program a smaller thread pitch
4-18 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)