Siemens Sinumerik 810T - Manual (Page 237)

3 Operating Sequences 01.93
3.2.11 ”Actual value setting” mode (”PRESET”)
The new ”Actual position” and the ”PRESET offset” for the X axis are displayed.
In the same way you enter the values for the other axes, and subsequently operate the
”STORE” softkey after input for each axis.
2. ”PRESET offset” with inclusive calculation of the tool offset
Use the same method to enter the identification no. for the other axes.
Using the keyboard, enter the desired tool
offset number D ... into the ”Compensation
number” input field,
and store it using the input key.
Using the keyboard, enter the identification
”Ident. No.” (see Section 3.1.3) for the X
axis into the ”Ident no.” input field - ”2” in
the example.
Store it using the input key.
First enter the designation of the desired
axis (”X” for the X axis in this example).
Then assign this axis the corresponding
value of the ”PRESET offset” using the
numerical keys and finally operate the
”STORE” softkey.
The new ”Actual position” and the ”PRESET offset” for the X axis are displayed.
The displayed value of the “PRESET offset” comprises:
– the entered value
– plus: the calculated tool offset.
You can clear all the ”PRESET offsets” at
once by operating the ”CLEAR PRESET-
OFFSET” softkey.
... ...
2
D
STORE
=
H X
7
CLEAR
PRE-OFF
3-130 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)