GE Industrial Solutions Galaxy Pulsar Edge - Manual (Page 139)

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011
139
Factory Defaults
Using any FTP client, perform the following steps to load default web pages:
1. Type: FTP x.x.x.x ( The controller should have a Working IP Address of 192.168.2.1).
ftp 192.168.2.1
Connected to 192.168.2.1
220 841 FTP Ready
2. Login as guest using the using the network administrator password (administrator).
User (192.168.2.1:(none)): guest
331 User name okay, need password
Password: administrator
230 Logged in
3. Change directory (cd) to the dflts directory by typing: cd dflts.
ftp> cd dflts
250 CWD command successful
4. Use the put command to copy the web pages to the controller.
ftp> put cp841-dflts.bin
200 Port command okay
150 Opening data connection for STOR (192.168.2.1,1576)
5. Verify the transfer by a message displayed indicating a successful file transfer.
226 File sent OK
ftp: 917504 bytes sent in 2.31Seconds 396.50Kbytes/sec.
6. Type bye to exit the FTP session.
ftp> bye
221 Goodbye!
Application Software
Using any FTP client, perform the following steps to load Application Software:
1. Change your directory to the PC directory where the Application code is stored.
2. Type: FTP x.x.x.x ( The controller should have a Working IP Address of 192.168.2.1).
ftp 192.168.2.1
Connected to 192.168.2.1
220 841 FTP Ready
3. Login as guest using the network administrator password (administrator).
User (192.168.2.1:(none)): guest
331 User name okay, need password
Password: administrator
230 Logged in