GE Industrial Solutions Galaxy Pulsar Edge - Manual (Page 155)

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011
155
The contactor interface type defaults are as follows:
DCN01 = CN1
DCN02 = CN2
DCN03 = CN3
DCN04-DCN08 = CN4
STC- Slope Thermal Compensation Related
Commands
obj,attr Description sta cha ope type Range of Values
sc1,ide Identifier  Text SC1
sc1,des Description
 
Text Slope Thermal Comp
sc1,stt State
 
number 0=disable 1=enable
sc1,rve Raise Voltage Enable   number 0=disable 1=enable
sc1,fse Probe Fail-Safe Enable
 
number 0=disable 1=enable
sc1,ltt Lower Temperature Threshold
 
number -5-20
°C or 23-68°F
sc1,ntt Nominal Temperature Threshold   number 15-30
°C or 59-86°F
sc1,utt Upper Temperature Threshold
 
number 30-55
°C or 86-131°F
sc1,spt Step Temperature   number 45-85
°C or 113-185°F
sc1,lsp Low temperature slope
 
number 1-10mV/
°C per cell
sc1,usp Upper temperature slope   number 1-10mV/
°C per cell
INP- Input Management Related
Commands
obj,attr Description sta cha ope type Range of Values
inmnn,ide Identifier

number m=module
nn=input number
Examples:
IN001=input 1 on controller
IN103=input 3 on module
with ID 1
inmnn,des Description  text See table below
inmnn,sn Serial Number

text Serial number
inmnn,brc Board Code

text Board code
inmnn,stt Input state  text 0=not alarming 1=alarming
inmnn,typ Input alarm type
 
text "" – no alarm, for in006, this
value allows the input to
be used for either group
standby or PBT.
Polarity is ignored.
"FAN1" - drives FAN1 alarm
"FAN2" – drives FAN2
alarm
"FAJ1" – drives FAJ1 alarm
"FAJ2" – drives FAJ2 alarm
"OSA1" – drives OSA1
alarm
"AMJ1" – drives AMJ1
alarm, not valid for
NE872 or other LVD
card inputs.