GE Industrial Solutions Galaxy Pulsar Edge - Manual (Page 78)

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011
78
Reboot
The maintenance page provides a Reboot button that issues a T1.317 command line
reboot command over the network. The controller will reboot upon receiving this
command and connectivity will have to be reestablished.
Settings Page
The Settings page is where system operational parameters, system device information, and alarm
thresholds are set-up and modified. Configurable parameters are sectioned under five main
headings: System, Reserve, Power, Communication, and Programming. Factory defaults are
provided for the various configurable items in the standard Pulsar Edge controller. Some defaults
are dependent on the battery type. Consult Appendix E for default settings of different battery.
Valve-Regulated Lead Acid (VRLA) batteries and default settings defined for the Standard
configuration are assumed in this section. Customer specific configurations may be different.
When there is doubt, contact Lineage Power technical support.
All items are field configurable. Modified settings are stored in non-volatile memory. The Pulsar
Edge requires time to update sectors in flash memory for changes. Allow approximately a minute
for the Pulsar Edge to accept and store modifications in non-volatile memory before removing
power to the unit.
CLI button