GE Industrial Solutions Galaxy Pulsar Edge - Manual (Page 49)

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011
49
into the following categories:
Alarms
Warnings
Status
Control/Operations
History
Configuration
Access to the main menu starts at the default front panel screen shown below.
Front Panel Default Menu
The front panel default screen displays the system
DC output bus voltage. Using the
◄► keys
allows the system load current to be displayed.
The operating mode of the system is also
displayed. Possible operating modes are: Float,
Battery On Discharge, Boost, Float-Temp Comp
etc. In converter systems, the text is fixed to
“converter plant”.
An alarm soft-key as well as the backlight will
indicate when alarms are present. Pressing the 
will access the alarm cut-off as well as the alarms
and warnings present in the system.
Pressing the  button accesses the main menu
and the feature categories previously listed.
Main Menu
Access to alarms, warnings, equipment status
detail, basic control and operations for
maintenance purposes, and system configuration
can be obtained.
Note: the Galaxy Pulsar Edge has the ability to
have a front Panel Password that limits
configuration as well as some operations. A
person with administrator level access can enable
this feature through the remote interfaces.
Standard Galaxy Pulsar Edge controllers are
shipped from the factory with this feature
disabled.
Front Panel PIN
The Galaxy Pulsar Edge controllers have the ability to restrict certain types of access from the
front panel of the unit. It has the ability to enforce a four-digit Power Identification Number (PIN)
requirement for users of the front panel for certain control/operations and configurable items.
These control/operations and configurations are generally considered the items that should only
be done during initial install or by specific personnel. This feature is shipped disabled from the
factory in the standard Galaxy Pulsar Edge controller offering and must be enabled by a remote