GE Industrial Solutions Galaxy Pulsar Edge - Manual (Page 163)

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011
163
ANET- Auxiliary Network Settings Related
Commands
obj,attr Description sta cha ope type Range of Values
net2,dom Static Domain Name
 
text (not used if DHCP enabled)
net2,msrv Mail host IP   IP
address xxx.xxx.xxx.xxx (0.0.0.0
will force a DNS lookup of
“mailhost”)
net2 is currently only used by an attached Gateway Card in the NX400 system.
Additional T1.317 Commands and Samples
ala Report Active Alarms
Syntax: ala
Description
This command reports all the active alarm conditions in the plant. One alarm message is listed
per line in the report. The table below lists the default alarm messages. Note that if user
changes the severity of the alarm, the corresponding change will show up in the alarm message.
However, alarm conditions with the RO severity will not be displayed, the rec command,
discussed later, should be used.
Alarm Message
MAJ, Multiple Rectifier Fail
MAJ, Multiple AC Fail
MAJ, Battery On Discharge
MAJ, High Voltage
MAJ, Sense Fuse
MAJ, Fuse Major
MAJ, Auxiliary Major
MAJ, Contactor 1 Open
MAJ, Contactor 1 Fail
MAJ, Major Communication Fail
MAJ, High Battery Current Shutdown
MAJ, Shorted Cell Detected
MAJ, Imminent Low V Shutdown
MAJ, Open String
MIN, Rectifier Fail
MIN, AC Fail
MIN, Thermal Probe Fail
MIN, Battery High Temp
MIN, Rect Redundancy Loss
MIN, High Battery Current
MIN, Minor Communication Fail
MIN, Circuit Pack Failure
MIN, Mid-cell V Monitor Fail
If no alarms are active “NO ACTIVE ALARMS” is reported.