Micromod RetroPAK: SLC Configuration Manual - Manual (Page 133)

Command Series Migration to MOD 30ML
Pre-configured Single Loop PID with Remote SP
To change the display tag name for the PID:
Open the display block PID Display and change the Display Tag under the Display tab.
See figure below:
Figure P3 .4.
PID with Remote
SP
Display Block
The display tag name also needs to be entered into the DIF (Display Interface Block) at
the top level of the database. See the section: Procedure for adding the Display Tag to
the Display Interface Block in the chapter Introduction for more information.
P3 - 7