Micromod RetroPAK: SLC Configuration Manual - Manual (Page 62)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
MAKING CONNECTIONS
15. The next step is to connect the blocks together.
• Click on the Multi-Segment connection item on the Algorithms menu to enable
connection mode. See figure below:
Figure 2 .30.
Algorithm -
Connection
• Move to the workspace on the right and click on the AIN block’s (FT-100 – source
block) output connection point as shown in the next figure. Notice that moving the cursor
over the output of a block, shows a fly-by box. This box shows the name of the output (for
example, in this case MODOUT).
Figure 2 .31.
Connecting blocks
• Move the cursor to the VCI block’s (destination block FY-100) input now. Moving the
cursor will draw a line.
Figure 2 .32.
Connecting blocks
• You will get a fly-by box that will say MODIN when you move over the input.
• Click on the input of the VCI block. See the figure above.
2 - 24