Micromod RetroPAK: SLC Configuration Manual - Manual (Page 21)

Command Series Migration to MOD 30ML
Function Codes – Introduction
• This will un-group the function blocks and place them where the grouped compound was.
When you uncompound a compound, the function blocks come out selected. You can
move all of them to a desired location by dragging them with the left mouse button
pressed.
a
The advantage of uncompounding is that you can place the function blocks at the same
level as other function blocks you might already have at that level thereby making the
connections easier.
To connect to a compound from outside of it:
• Select the connector and select the attribute to connect from the desired block.
• Drag the line to the compound and click on it. See the figure below:
Figure 1 .8.
Right Angle
connection
• The Choose Parameter menu will be displayed as shown in the next figure:
Figure 1 .9.
Choose Parameter
• Select the desired jump object (if it was already present, for example PID.S1 in the above
figure) from the list and then click on OK.
1 - 13