Micromod RetroPAK: SLC Configuration Manual - Manual (Page 66)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
Figure 2 .39.
Cancel Connection
17. Connect the PID output from the compound to the analog output:
• Select the connector and then click on the FC156 PID (PV/LOCAL SP) compound and
click on it. The Choose Parameter menu will be displayed as shown below: Select PID.N
from the menu and click on OK.
Figure 2 .40.
Choose Parameter
• Drag the connection line to left of the AOUT block and connect to the Input point. The
connected blocks and the compound will look like in the next figure:
2 - 28