Micromod RetroPAK: SLC Configuration Manual - Manual (Page 261)

Command Series Migration to MOD 30ML
Function Codes 25 and 41 – Analog/Digital Input
Figure 25 .3.
Function Code 25
and 41
To configure the source of the data:
Click on the Data Source tab of the block. See the next figure. Specify the following:
Instrument Number – This is the ICN address of the instrument sending data. This is the
equivalent of S1 in the Bailey Function code 25 or 41.
OC Number – This is the occurrence number of the OC block (FC 28) configured in the
sending instrument. This is the equivalent of S2 in the Bailey Function code 25 or 41.
Port Number – This is the port number of the ICN communication channel in the
receiving instrument.
25 - 3