Micromod RetroPAK: SLC Configuration Manual - Manual (Page 65)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
Figure 2 .37.
Choose Parameter
• Select PID.S1 from the list and then click on OK. This will complete the connection for
the process variable input. The connection will look like in the next figure:
Figure 2 .38.

If you made a mistake while connecting, or if you do not know where to connect, you
can always cancel it or get out of the connection mode by clicking on the right mouse
button to show a menu as shown below:
• Select Cancel from this menu to cancel the connection.
2 - 27