Micromod RetroPAK: SLC Configuration Manual - Manual (Page 59)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
• Resize the block by dragging one of the handles (corner or side)
Figure 2 .26.
Move, Resize and
Configure
14. Configure these blocks:
• Configure the Analog Input block.
• Double-click on the AIN block to open its Properties menu as shown below:
Figure 2 .27.
AIN Block
• Type FT-100 as the name.
• Select Current as the Input type from the drop-down menu.
• Type the Input number as 2 and Description as shown in the above figure. This is the
built-in input 2 of the MOD 30ML. Note that changing the input type changes the Input
Low and High signal ranges automatically. This can also be manually changed.
• Click on OK when done.
2 - 21