Micromod RetroPAK: SLC Configuration Manual - Manual (Page 156)

Command Series Migration to MOD 30ML
Pre-configured Dual Loop PID with Remote SP
To connect / change the value of the Gain Multiplier input (S11):
Make a connection into the PID.S11 signal of the compound.
To enter a local value, open the respective PID block and select the Control tab. Check
the Internal checkbox in the Gain Multiplier Input field and enter a value in the value
in the text field. See the next figure:
Figure P4.7.
Dual PID with
Remote SP
P4- 10