Micromod RetroPAK: SLC Configuration Manual - Manual (Page 26)

Command Series Migration to MOD 30ML
Function Codes – Introduction
THE CONFIGURATION PROCESS
The steps involved configuring a MOD 30ML or Modcell controller are listed below:
1. Create a Workspace document in ViZapp
2. Create a Project document in ViZapp
3. Add a new instrument database for each controller to the project document.
4. Configure the instrument database in ViZapp.
5. Save and compile the instrument database
6. Configure the OPC Server (XModbus or ICN depending on which communication
protocol is used for connecting the controllers to the computer running ViZapp and
the OPC Server).
7. Add a device in the OPC Server for each controller that needs to be configured.
Communication settings for the device and the comm. Port should match that of the
instrument.
8. Download the compiled database from ViZapp using the OPC Server to the desired
instrument.
These steps are further explained in the next chapter and in the ViZapp training manual.
1 - 18