Micromod RetroPAK: SLC Configuration Manual - Manual (Page 63)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
Figure 2 .33.
Connecting blocks
• The connection will now be complete. The connection line will have the source name and
destination name displayed right on it as shown in the above figure.

The input connection points are on the left side of the blocks and the output connection
points are on the right hand side.
There might be more than one input or output for each block. All the inputs or outputs
need not be shown as connections attached to the block. To see all the inputs or outputs of
a block, you need to click right on the block in the connection mode.
As an example, the figure below shows the possible inputs of the PID block (destinations
for inputs into this block).
Figure 2 .34.
Choose parameter
for connecting
16. Connect the corrected flow as the process variable:
• Let us take Right angle connector this time. The right angle connector will connect the
blocks by horizontal and vertical lines instead of making a point to point straight
connection.
• Select the right angle connector from the Algorithms menu as shown below:
2 - 25