Micromod RetroPAK: SLC Configuration Manual - Manual (Page 24)

Command Series Migration to MOD 30ML
Function Codes – Introduction
Figure 1 .13.
Cancel Connection
To add a loop compound: Select the Loop Cpd (Loop compound) block from the
Algorithms window add it to the document. Do this by first locating the block in the menu
by selecting the All submenu at the bottom and then by dragging the scroll bar on the right
up/down. See the next figure:
Figure 1 .14.
Algorithms menu
• Drag the Loop Cpd block (Loop Compound) from the Algorithms menu on the left frame
to the right frame. Click on the Loop Cpd block with your left mouse button and then
drag it to the instrument document. Click on the mouse button to place the Loop
compound block with the other existing blocks (IF, SE, DIF and ST) on the right frame.
• Opening and closing of loop compound is exactly same as that of the compound explained
in the previous section.
1 - 16