Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 108)

Survey Pro Reference Manual
R-100
Edit : Opens the Cell Phone Settings or IP Modem Settings screen
(Page R-102 or R-103, respectively) where the selected data modem
configuration can be modified.
Delete : Deletes the selected data modem configuration.
Modem Serial Comms Screen
The Modem Serial Comms. screen is used to change the settings for
communication between the base or rover receiver and the data
modem.
GPS Receiver Port
: is where you select the
serial port the receiver will use to communicate
with the modem.
Baudrate
: is where you select the baud rate the
receiver will use to communicate with the
modem.
Parity
: is where you select the parity the
receiver will use to communicate with the
modem. This setting disabled for receivers that
do not support user defined parity setting.
Defaults : automatically sets all the selectable values to their
defaults based on the current receiver hardware.
Receiver Set : sets the selected modem communication settings for
the specified port on the receiver.
Note: The modem communication settings are also set in the receiver
during the base and rover setup procedure. Therefore, you will not
usually have to use the Receiver Set button on this page.
Radio Settings Screen
The Radio Settings screen is used to configure settings of the base or
rover radio modem. All settings available are described below.
However, not all radios support all of the described settings, so if you
do not see one of these fields, it is because the radio type does not
support it.