Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 164)

Survey Pro Reference Manual
R-156
Check Point
Survey Check Point .
The Check Point screen compares the rod location with an existing
point in the project. This routine is similar to the Check Backsight
routine (Page R-122) and is used to verify that the rod and/or the
total station is over the correct point. This routine does not store a
new point.
Point: is the point from the project that will be
compared to the observed point (rod location).
Height of Rod: is the length of the rod.
Backsight… : opens the Backsight Setup screen
(Page R-118).
Take Shot : takes a shot and displays the
deltas between the observed point and the
selected point. High delta values can indicate
either the rod and/or total station is over the
wrong point. The deltas can also be viewed in
the Results screen and Map screen.
: is a shortcut to the Surveying Settings screen (Page R-45).