Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 291)

Stakeout Menu
R-283
Stake to Line – Screen Two
The second screen is where the staking is performed. The graphic
display of this screen will change depending on how close the rod is to
the specified line. The initial screen that is displayed before a shot is
performed shows the position of the total station, the line of the
backsight and the specified line to stake. Each type of graphic is
displayed below.
HR: is the rod length.
EDM: This button can be toggled to shoot in
various EDM modes. The options available
depend on the total station being used.
Consult the total station’s documentation for
more information on the EDM modes that it
supports.
BACK / FORWARD: is the distance that the rod
must travel BACK (away from the total station)
or FORWARD (toward the total station) in
order to occupy the specified line.
LEFT of Line / RIGHT of Line / ON LINE: is displayed if the rod is
to the left or right side of the line, or is on the line. The LEFT and
RIGHT
side is determined as if occupying the Start Point and facing
the Foresight Point or Direction of the line, specified in Screen One.
ON LINE
is determined if you are within the Horizontal Distance
Tolerance
specified in the Stakeout Settings screen (Page R-47).
Offset Dist.: is the perpendicular offset from the specified line to
the rod. This is the minimum distance that the rod must travel to
occupy the line.
Station: is the station on the specified line where the offset occurs,
relative to the Start Point.