Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 424)

Survey Pro Reference Manual
R-416
Next Station : advances the Station to Stake by
the Station Interval.
Note: If the Stake Corners option is selected in
the Stakeout Settings screen, the Next Station
button will also stop at any horizontal or
vertical alignment node, and the beginning and
end of any widening and super elevation that
falls within the interval.
<< , >> : These buttons are used to select the particular node, or
an offset to it, from your road profile that you wish to stake. The
segment name at the selected node is also displayed. If staking the
centerline with an offset, the side of the road that the offset occurs is
also displayed.
Offset: When checked, allows you to specify a horizontal offset
distance away from the centerline to stake as opposed to staking the
actual node locations.
Note: A positive value offset is applied at the specified distance from
each node away from the centerline. A negative value offset is
applied at the specified distance from each node toward the
centerline.
Note: If an offset occurs past the edge of the road, no vertical or cut /
fill information will be computed for that point.
Subgrade: When checked, allows you to specify a vertical offset from
the actual node locations. Positive values result in the stake location
occurring below the selected node. Negative values result in the stake
location occurring above the selected node.
Backsight… : opens the Backsight Setup screen (Page R-118).
< Back : returns to the previous screen.