Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 72)

Survey Pro Reference Manual
R-64
Edit Polylines
Job Edit Polylines .
The Edit Polylines screen is used to add, edit, and delete polylines in
the current job.
The first screen will display a list of all the
polylines that are stored in the current job.
Selecting any of the polylines listed will display
a horizontal (overhead) and vertical (side) view
of that polyline.
New… : will open the Polyline Editor where a
new polyline can be created.
Edit… : will open the selected polyline in the
New Polyline screen, described below.
Delete… : will delete the selected polyline.
Screen Two – New Polyline
The second screen is used to define all of the points that are used in
the polyline. Any curve information will be entered later, but the end
points must still be selected at this point.
The current polyline is shown on color displays
with bold red lines and all other polylines are
shown using thin black lines. Only the current
polyline data can be edited.
Tap Points… : opens a map view where the
points in your polyline can be tapped. They
must be tapped in the order that they occur in
the polyline.
To/From… : Opens the Point List screen (Page
R-443) where a point list can be created.