Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 304)

Survey Pro Reference Manual
R-296
Note: The Vertical Map will show an X at the location of each
previous shot. This can be useful in determining if the current
terrain will never intersect the slope (no catch point).
• Horizontal Map : displays an overhead view of the job.
• Shot Data : displays the shot data for the latest shot.
Left / Right: displays if a Cut or Fill slope is being computed and if it
is on the Left or Right side of the road, respectively.
Rod Elev: is the current elevation at the rod location.
Des. Slope: is the design cut or fill slope.
Obs. Slope: is the computed (observed) cut or fill slope based on the
last shot and the corresponding hinge point.
Cut / Fill: is the cut or fill required for the current rod location to be
positioned on the design slope.
Toward CL / Away CL: is the computed horizontal distance that the
rod must move either toward the centerline or away from it,
respectively, before it is positioned at the catch point.
Note: The computed horizontal distance is based on the observed
terrain computed from the last two shots. If only one shot has been
taken, it is assumed that the terrain is level when computing this
value.
On Station / Back Sta / Ahead Sta: informs you if the rod is on the
station being staked, or the distance it must move (parallel to the
centerline) back or ahead to be on the correct station.
HD to HP: is the horizontal distance from the rod to the hinge point.
VD to HP: is the vertical distance from the rod to the hinge point.
HD to CL: is the horizontal distance from the rod to the centerline.
VD to CL: is the vertical distance from the rod to the centerline.
Topo SS… : will store the last shot taken as a side shot.