Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 198)

Survey Pro Reference Manual
R-190
Data Collection
Survey Data Collection .
The Data Collection screen is used to collect GPS measurements and
store new points in the job.
GPS Status
: displays the current solution type,
the data modem reception quality, the number
of satellites used and the horizontal precision
computed by the receiver. When this area is
tapped, the GPS Status screen (Page R-172)
will open.
Point
: is where you enter the point name for
the next point to be stored.
Description
: is where you enter the description
for the next point to be stored.
Set HR : displays the current antenna
measurement and measure to setting. You can change the antenna
measurement by entering a new value in the edit box. This new
antenna height will be sent to the receiver with your next data
collection point. You can change both the antenna measurement and
measure to setting by tapping on Set HR to open the Receiver
Antenna screen (Page R-184).
Post Process: opens the Receiver Session screen (Page R-202), where
you can occupy a point for a post processing only session. This allows
you log a session in the post processing file using an existing point
name without changing that point record in the job file.
Control : opens the Control Points screen (Page R-190).
Topo SS : stores a point with a single epoch of data. The current
position is checked against the criteria, and if acceptable, the point is
stored.