Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 61)

Job Menu
R-53
Repetition Settings
Job Settings Repetition .
The Repetition Settings card contains the settings that control how
repetition shots are performed and acceptable tolerances.
Horizontal Tolerance: a warning message will
be displayed if a horizontal angle exceeds the
tolerance entered here during a repetition shot.
Zenith Tolerance: a warning message will be
displayed if a vertical angle exceeds the
tolerance entered here during a repetition shot.
Distance Tolerance: a warning message will
be displayed if a distance exceeds the tolerance
entered here during a repetition shot.
; Shoot Distance To Backsight : When
checked, a distance will be measured to each
shot to the backsight. When unchecked, only the angles are
measured.
; Do Not Shoot Reverse Distances : When checked, distances are
not measured during reverse shots.
; Enable Automatic Repetition : When checked, all remaining shots
after the first shot to the backsight and foresight will occur
automatically when using a motorized instrument.
Shooting Sequence: specifies the order that the shots are taken
from the following options:
• BS > FS ^ FS > BS: Backsight, Foresight, flop Foresight
Backsight
• BS > FS ^> BS > FS: Backsight, Foresight, flop Backsight,
Foresight
• BS ^ BS > FS ^ FS: Backsight, flop Backsight, Foresight, flop
Foresight
• FS ^ FS > BS ^ BS: Foresight, flop Foresight, Backsight, flop
Backsight