Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 312)

Survey Pro Reference Manual
R-304
Vertical Offset : is the offset distance that is below the design
location (when D is selected) or above the design location (when U
is selected).
Grade: specifies a slope from the specified line to the parallel line
that is being staked. When this is a non-zero value, the elevation for
the staked points will increasingly differ from the design elevations
as the Offset value increases.
Height of rod: is the length of the rod.
Backsight… : opens the Backsight Setup screen.
< Back : returns to the previous screen.
Solve> : opens the third Stake Line and Offset screen, described
next.
Note: A motorized total station will automatically turn toward the
design point after pressing Solve> depending on the configuration of
the Stakeout Settings screen (Page R-47).
Stake Line and Offset – Screen Three
Station: displays the current station that is
being staked.
H. Offset: displays the offset distance of the
line being staked from the specified line and if
it is on the Right or Left side of the specified
line.
From Gun to Design Point: displays the
direction and distance that the total station
must aim toward so that it is facing the current
station.
Circle Zero : is used to modify the circle on the
total station so that the angle right reading will be zero when it is
facing the current target, which can sometimes be easier than