Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 214)

Survey Pro Reference Manual
R-206
Projection – TDS Localization Mode
The Projection screen is described below for when the horizontal
projection mode is set to TDS Localization.
Use this setting when you want ground level
coordinates, and there is no projection and no
datum to define a geodetic coordinate
transformation. In this mode, a default map
projection is created with your first RTK base
setup. You collect GPS measurement on points
with known local coordinates, and solve a
Localization adjustment. The Localization
adjustment will translate, rotate, and scale the
default map projection’s (y,x) into your local
coordinates (N,E).
Show Details… : opens the Projection Details screen, where the
complete details of the localization solution, reference map projection,
and Geoid model are displayed.
Reset Origin… : opens the Localization Set Zone screen (Page R-207),
where you can enter the parameters of the intermediate mapping
plane to be used for the localization adjustment.
Note: This step is usually not necessary, since the intermediate
mapping plane is automatically set up by default using the location of
the first RTK base setup in this job. However, if the first base is far
away (more than 10km), or it is considerably higher or lower (+/-
200m) you may wish to enter the parameters of the intermediate
mapping plane.
Solve Localization… : opens the Solve Localization wizard (Page R-
210), where control points can be selected and the horizontal and
vertical localization are solved.
Switch to Mapping Plane… : switches the horizontal projection mode
from Ground – TDS Localization to Mapping Plane (Page R-218).