Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 182)

Survey Pro Reference Manual
R-174
Receiver mode
: (see the Receiver Status card,
Page R-172.)
Modem Reception
: displays two values
indicating the data modem signal quality. This
information is only displayed if the receiver is
in rover mode.
Signal
Latency: displays the age of the
differential correction used in the current GPS
solution. This value should be one second or
less for good RTK solutions. If this value is
consistently greater than one second, check the
data modem link.
Reception
: displays the receiver’s estimation of the percent quality of
the radio link.
Dial : Dials the cell phone or IP modem using the configuration set in
the Cell Phone Settings or IP Modem Settings screen, respectively.
Hang up : Disconnects the cell phone or IP modem connection.
Post Process
The Post Process card displays information about GPS raw data
logging for post processing.
Note: Some GPS receivers monitor post
processing session status while others simply
record event markers in the log file. If your
receiver does not monitor sessions, some fields
are not displayed.
Status
: displays information about the
recording. It will be one of four values
• No Communication: we are not
receiving a response to commands.
• No Data: we are receiving an unknown or a bad response to
commands.